Fitting Instructions

 If you have a male "click-on! part on your tap, UNSCREW & REMOVE IT.

 Screw onto the Tap the 320 Hoselink Tap Connector. The Tap Connector fits 3-size taps. Remove size reducers to fit your tap.

 1. Cut the hose cleanly at right angles

 2. Slip the threaded yellow nut over the end of the hose. Place the white split ring onto the end of the hose, so that it is flush with the end of the hose.

 3. Place the hoselink body on a hard, flat surface and push hose & split ring over stem of Hoselink body until it touches the bottom & can go no further.

We recommend you place the end of the hose in hot water to soften it, to ensure the hose is pushed to the very bottom of the stem!

THIS STEP IS CRUCIAL! 

4. Slide threaded nut to hoselink body & tighten.